Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying ECM Retainer Clips

Courtesy of SUZUKI OF AMERICA CORP.

Slide the ECM into the retainer until the clips (1) engage the ECM.

Fig 2: Identifying Engine Control Module Retainer
Courtesy of SUZUKI OF AMERICA CORP.
Grasp the ECM retainer and slide the retainer forward until the retainer locks against the 4 clips on the battery cover.

Fig 3: Identifying Engine Wiring Harness Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Connect the engine wiring harness electrical connector (2) to the ECM.
Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION .
If a NEW ECM was installed, reprogram the ECM. Refer to ENGINE CONTROL MODULE PROGRAMMING AND SETUP (LY7) .