LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Engine Electrical Devices) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying APP Assembly Attachment Bolts
G05469871Courtesy of SUZUKI OF AMERICA CORP.
  1. Install the upper attachment bolt into the APP assembly.
  2. Install the APP assembly into the vehicle.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the remaining attachment bolts into the APP assembly.

    Tightening torque 

    Tighten the bolts to 25 N.m (18 lb ft). 

    Fig 2: Identifying Accelerator Pedal Position Sensor Connector
    G05469872Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the CPA to the APP sensor harness connector.
  6. Install the driver knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
  7. Install the instrument panel left lower closeout panel. Refer to INSTRUMENT PANEL INSULATOR PANEL REPLACEMENT - LEFT SIDE .
scientia non olet · About LEMON Manuals