Engine Front Cover Assemble

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: ENGINE FRONT COVER CLEANING AND INSPECTION

Special Tool

EN-46103 Camshaft Actuator Valve Seal Remover/Installer

J 29184 Output Shaft Seal Installer

Fig 1: Installing Crankshaft Front Oil Seal Into Engine Front Cover Using J 29184

Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

Install the NEW crankshaft front oil seal into the engine front cover using the J 29184.

Fig 2: Placing Seal Into Position With Notches In Seal Down
Courtesy of SUZUKI OF AMERICA CORP.
Place the seal into position with the notches (1) in the seal down. The notches (1) will face in board when properly installed.

Fig 3: Installing Camshaft Position Actuator Valve Oil Seals Into Engine Front Cover Using EN-46103
Courtesy of SUZUKI OF AMERICA CORP.
Install the NEW camshaft position actuator valve oil seals into the engine front cover using the EN-46103.
Reference: ENGINE FRONT COVER INSTALLATION (FOURTH DESIGN)