LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Sun Roof/T Top/Convertible Top) >> Repair Instructions >> Sunroof Track Timing/Synchronization
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sunroof Track Timing/Synchronization

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before retiming the module, the actuator/motor must be removed. Refer to SUNROOF MOTOR/ACTUATOR REPLACEMENT .
    NOTE: If the sunroof actuator is the only part being serviced, follow the power sunroof actuator replacement procedure for the sunroof actuator to sunroof window timing. Refer to SUNROOF MOTOR/ACTUATOR REPLACEMENT .
    A new replacement power sunroof actuator is set to the fully closed and flush position at the factory.
    Fig 1: Identifying Drive Slide And Bracket Gap Dimension
    G05471419Courtesy of SUZUKI OF AMERICA CORP.
  2. Remove the sunroof window. Refer to SUNROOF WINDOW REPLACEMENT .
  3. Fabricate a gage (2) 46.8 +/- 0.5 mm (1.84 in) wide (A).

    A piece of thick paper will work.

  4. Set the gage into the track near the rear of the opening between the move drive slide (1) and the bracket.
  5. Move the drive slide fore or aft in order to get the proper setting.
  6. Repeat steps 3 and 4 for the other side.
  7. Install the sunroof window. Refer to SUNROOF WINDOW REPLACEMENT .
  8. Install the sunroof actuator. Refer to SUNROOF MOTOR/ACTUATOR REPLACEMENT .
  9. Operate the sunroof through all functions to ensure proper operation.
scientia non olet · About LEMON Manuals