LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Limited, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0496: Evaporative Emissions (EVAP) System Continuous Purge Flow >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Disconnect the EVAP purge solenoid valve electrical harness connector.
  2. Start the engine.
  3. Command the EVAP vent closed.
  4. Increase the engine speed to 1,200-1,500 RPM.
  5. Observe the scan tool fuel tank pressure (FTP) sensor parameter. Verify the scan tool FTP sensor parameter is -0.9 to +0.9 mm/Hg (-0.5 to +0.5 in H2O).
    • If not within the specified range, replace the EVAP purge solenoid valve.
  6. Ignition ON, engine OFF, disconnect the EVAP purge solenoid valve pipe.
  7. Observe the scan tool FTP sensor parameter. Verify the FTP sensor parameter is -0.9 to +0.9 mm/Hg (-0.5 to +0.5 in H2O)..
    • If not within the specified range, replace the FTP sensor.
scientia non olet · About LEMON Manuals