April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

Fig 1: Identifying Fuel Pressure Gage

G05465665

Courtesy of SUZUKI OF AMERICA CORP.

Relieve the fuel system pressure, if required. Perform the following steps:
WARNING: Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the connection of the fuel pressure gage is complete.
1. Wrap a shop towel around the fuel rail service port.
2. Place the hose on the J 34730-1A Gage into an approved gasoline container.
3. Open the valve on the J 34730-1A Gage in order to bleed any fuel from the fuel rail.
4. Close the valve on the J 34730-1A Gage.
5. Remove the hose on the J 34730-1A Gage from the approved gasoline container.
6. Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.
  CAUTION:
  Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
  - The fuel pipe connections
  - The hose connections
  - The areas surrounding the connections
Disconnect the J 34730-1A Gage from the fuel rail service port.
Install the fuel rail service port cap.
Tighten the fuel fill cap.