LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Limited, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Diagnostic Information and Procedures >> Liftgate Release Malfunction >> Circuit/System Testing >> Liftgate Release Switch Malfunction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Liftgate Release Switch Malfunction

  1. Ignition OFF, disconnect the harness connector at the liftgate switch.
  2. Test for less than 1 ohm between the ground circuit terminal C and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, test for greater than 9 volts between the signal circuit terminal A and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the signal circuit terminal A and ground. Verify the scan tool Trunk Release Solenoid parameter is On.
    • If not the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the liftgate release switch.
scientia non olet · About LEMON Manuals