LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> SX4 LE, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Advanced Air Bag System >> Repair Instructions >> Enabling Air Bag System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Enabling Air Bag System

  1. Confirm that battery negative (-) cable is disconnected.
  2. Turn ignition switch to "LOCK" position and remove key.
  3. Connect yellow connector (1) of driver air bag (inflator) module by pushing connector till click is heard from it.
    Fig 1: Connecting Yellow Connector Of Driver Air Bag (Inflator) Module
    G05472323Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect yellow connector (1) of passenger air bag (inflator) module by pushing connector till click is heard from it.
    Fig 2: Connecting Yellow Connector Of Passenger Air Bag (Inflator) Module
    G05472324Courtesy of SUZUKI OF AMERICA CORP.
  5. Install driver and passenger side front pillar lower trim.
  6. Connect yellow connector (1) of side-air bag (inflator) module by pushing connector till click is heard from it.
    Fig 3: Connecting Yellow Connector Of Side-Air Bag (Inflator) Module
    G05472325Courtesy of SUZUKI OF AMERICA CORP.
  7. Connect connector of side curtain-air bag (inflator) module and then install each trim as follows.

    For hatchback model: 

    1. Connect yellow connector (1) by pushing connector till click is heard from it.
    2. Install right-side rear quarter lower trim.
      Fig 4: Connecting Side Curtain-Air Bag (Inflator) Module Connector (For Hatchback Model)
      G05472326Courtesy of SUZUKI OF AMERICA CORP.

    For sedan model with rear separate seat: 

    1. Connect black connector (1).
    2. Lock connector with lock button (2).
    3. Install rear pillar inner trim.
    4. Install rear seat side back referring to REAR SEAT COMPONENTS .
    5. Install rear side sill scuff.

    For sedan model with rear bench seat: 

    1. Connect black connector (1).
    2. Lock connector with lock button (2).
    3. Install rear pillar inner trim.
    4. Install seat cushion and seat back referring to REAR SEAT COMPONENTS
      Fig 5: Connecting Side Curtain-Air Bag Module Connector (For Sedan Model With Rear Bench Seat)
      G05472327Courtesy of SUZUKI OF AMERICA CORP.
  8. Install "A/B" fuse to fuse box.
  9. Connect negative (-) cable at battery.
  10. Turn ignition switch to ON position and verify that "AIR BAG" warning light flashes 6 times and then turns OFF. If it does not operate as described, perform AIR BAG DIAGNOSTIC SYSTEM CHECK  .
scientia non olet · About LEMON Manuals