Fail Safe Table

WARNING: This page is about a different variant/trim than selected.

This function is provided by the safe mechanism that assures safe driveability even when the solenoid valve, sensor or its circuit fails. The following FAIL SAFE TABLE shows the fail safe function for each fail condition of sensor, solenoid, TCM or its circuit.

FAIL SAFE TABLE

DTC No.	Trouble area	Fail safe operation
P0705	Transmission Range Sensor Circuit Malfunction (P R N D L Input)	TCM assumes position of transmission range sensor to be the following order of priority depending on input signals. N > R > L > 2 > 3 > D > P
P0707	Transmission Range Sensor Circuit Low	TCM assumes shift position to be D range.
P0712	Transmission Fluid Temperature Sensor "A" Circuit Low	TCM assumes transmission fluid temperature to be 200°C (392°F) and controls transaxle.
P0713	Transmission Fluid Temperature Sensor "A" Circuit High
P0717	Input Speed Sensor "A" Circuit No Signal	Line pressure is controlled to maximum pressure, lock-up function is inhibited and gear position is fixed according to select lever position as follows. D range: Fixed to 4th gear position 3 range: Fixed to 4th gear position 2 range: Fixed to 3rd gear position L range: Fixed to 1st gear position
P0722	Output Speed Sensor Circuit No Signal
P0961	Pressure Control Solenoid "A" Control Circuit Range/Performance	Line pressure is controlled to maximum pressure, lock-up function is inhibited and gear position is fixed according to select lever position as follows. D range: Fixed to 4th gear position 3 range: Fixed to 4th gear position 2 range: Fixed to 3rd gear position L range: Fixed to 1st gear position
P0962	Pressure Control Solenoid "A" Control Circuit Low
P0963	Pressure Control Solenoid "A" Control Circuit High
P0973	Shift Solenoid "A" Control Circuit Low
P0974	Shift Solenoid "A" Control Circuit High
P0976	Shift Solenoid "B" Control Circuit Low
P0977	Shift Solenoid "B" Control Circuit High
P1702	Internal control module memory check sum error
P2763	Torque Converter Clutch Pressure Control Solenoid Control Circuit High	TCM is controlled as follows. Gear position is fixed in 1st gear when vehicle speed is 10 km/h (6 mile/h) or less. Up shifting to 4th gear is inhibited when transmission fluid temperature is 150°C (302°F) or more.
P2764	Torque Converter Clutch Pressure Control Solenoid Control Circuit Low
U0073	Control Module Communication Bus Off	TCM is controlled as follows. Line pressure is controlled to maximum pressure. TCM assumes throttle position signal to be 0%. TCM assumes engine speed to be 0 RPM. After 15 minutes pass from detecting malfunction, TCM assumes engine coolant temperature to be 90°C (194°F). Gear position is fixed according to select lever position as follows. D range: Fixed to 4th gear position 3 range: Fixed to 4th gear position 2 range: Fixed to 3rd gear position L range: Fixed to 1st gear position
U0100	Lost Communication With ECM / PCM "A"	TCM is controlled as follows. Line pressure is controlled to maximum pressure. Lock-up function is inhibited. TCM assumes throttle position signal to be 100%. TCM assumes engine speed to be 0 RPM. After 15 minutes pass from detecting malfunction, TCM assumes engine coolant temperature to be 90°C (194°F). Gear position is fixed according to select lever position as follows. D range: Fixed to 4th gear position 3 range: Fixed to 4th gear position 2 range: Fixed to 3rd gear position L range: Fixed to 1st gear position