ABS (ESP®) Hydraulic Unit / Control Module Assembly Removal and Installation: Installation

Install hydraulic unit / control module assembly by reversing removal procedure noting the following.
Install ABS hydraulic unit / control module assembly bracket bolt as follows.
1. Tighten bracket bolt (1) and (2) by hand.
2. Then tighten bracket bolt to specified torque.
  Tightening order (1) → (2)
  
  NOTE: Brake pipe flare nuts (3) from master cylinder is attached M10 nut (ABS model) or M12 (ESP® model).
Tightening torque

Brake pipe flare nut for M10 a: 16 N.m (1.6 kg-m, 11.5 lb-ft)

Brake pipe flare nut for M12 b: 19 N.m (1.9 kg-m, 14.0 lb-ft)

ABS hydraulic unit / control module assembly bolt c: 9 N.m (0.9 kg-m, 6.5 lb-ft)

ABS hydraulic unit / control module assembly bracket bolt d: 26 N.m (2.6 kg-m, 19.0 lb-ft)

Fig 1: Identifying Brake Lines And Hydraulic Unit Bracket Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Bleed air from brake system referring to AIR BLEEDING OF BRAKE SYSTEM .
Check each installed part for fluid leakage.
For ESP® model, perform ABS (ESP®) HYDRAULIC UNIT / CONTROL MODULE ASSEMBLY COMPONENTS .
Perform ABS HYDRAULIC UNIT OPERATION CHECK .
Turn ignition switch to OFF position once and then ON position. In this state, make sure that SLIP indicator light turns off.
Check DTC(s) are not stored in hydraulic unit / control module.