Compressor Assembly Removal and Installation: Installation
CAUTION:
Be sure to use HFC-134a (R-134a) compressor oil.
Reverse removal procedure noting the following instructions.
- If compressor is replaced, pour new compressor oil referring to PRECAUTIONS ON REPLENISHING COMPRESSOR OIL .
- Install accessory (A/C compressor) drive belt referring to ACCESSORY DRIVE BELT REMOVAL AND INSTALLATION .
- Install P/S fluid reservoir from its bracket.
- Fill engine coolant to radiator.
- Evacuate and charge system referring to "EVACUATION " and "Charge" in Operation Procedure for Charging A/C with Refrigerant .
- Tighten compressor mounting bolts in numerical order ("1" through "3") to specified torque as shown in figure. (J24B model)
- Tighten compressor mounting bolts "2" temporarily and install mounting bolt "1" and "3", and then tighten mounting bolts in numerical order ("1" through "3") to specified torque as shown in figure. (N32A model)
Tightening torque
Compressor mounting bolt (a): 25 N.m (2.5 kg-m, 18.0 lbf-ft) (by the specified procedure)