Accelerator Pedal Position (APP) Sensor Inspection

WARNING: This page is about a different variant/trim than selected.

Remove accelerator pedal assembly (incorporating APP sensor assembly). See ACCELERATOR PEDAL ASSEMBLY (INCORPORATING APP SENSOR) REMOVAL AND INSTALLATION .
Check APP sensor output voltage as follows.
If faulty condition is found, replace accelerator pedal assembly (incorporating APP sensor assembly). See ACCELERATOR PEDAL ASSEMBLY (INCORPORATING APP SENSOR) REMOVAL AND INSTALLATION .
1. Connect three new 1.5 V batteries (1) in series, and check that total voltage is 4.5 - 5.0 V.
2. Connect voltmeter (2) and batteries to APP sensor as shown in figure.
  [A]: APP sensor (main)
  
  Fig 1: Checking APP Sensor (Main) For Voltage
  Courtesy of SUZUKI OF AMERICA CORP.
  
  [B]: APP sensor (sub)
  
  Fig 2: Checking APP Sensor (Sub) For Voltage
  Courtesy of SUZUKI OF AMERICA CORP.
3. Check that voltage varies depending on accelerator opening angle as the following graph.
  
  Fig 3: APP Sensor Voltage Graph
  Courtesy of SUZUKI OF AMERICA CORP.