LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> Equator RMZ-4 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (VQ40DE) - (3 Of 5) >> DTC P2122, P2123: APP Sensor >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

DIAGNOSIS PROCEDURE

Step Action YES NO
CHECK GROUND CONNECTIONS 
  1. Turn ignition switch OFF.
  2. Loosen and retighten three ground screws on the body. Refer to [POWER SUPPLY AND GROUND CIRCUIT CHECK ].
G06441617Courtesy of SUZUKI OF AMERICA CORP.

OK or NG 
GO TO 2. Repair or replace ground connections.
CHECK APP SENSOR 1 POWER SUPPLY CIRCUIT 
  1. Disconnect accelerator pedal position (APP) sensor harness connector.
G06441618G06441619Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.

  1. 2. Turn ignition switch ON.
  2. 3. Check voltage between APP sensor terminal 2 and ground with SDT or tester.
G06441618G06441619Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.

Voltage: Approximately 5V 


OK or NG 
GO TO 3. Repair open circuit or short to ground or short to power in harness or connectors.
CHECK APP SENSOR 1 GROUND CIRCUIT FOR OPEN AND SHORT 
  1. Turn ignition switch OFF.
  2. Disconnect ECM harness connector.
  3. Check harness continuity between APP sensor terminal 4 and ECM terminal 82.

    Refer to WIRING DIAGRAM .

    Continuity should exist. 

  4. Also check harness for short to ground and short to power.

OK or NG 
GO TO 4. Repair open circuit or short to ground or short to power in harness or connectors.
CHECK APP SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
  1. Check harness continuity between ECM terminal 106 and APP sensor terminal 3. Refer to WIRING DIAGRAM .

    Continuity should exist. 

  2. Also check harness for short to ground and short to power.

OK or NG 
GO TO 5. Repair open circuit or short to ground or short to power in harness or connectors.
CHECK APP SENSOR 
Refer to [P2122, P2123 APP SENSOR ].
OK or NG 
GO TO 7. GO TO 6.
REPLACE ACCELERATOR PEDAL ASSEMBLY 
  1. Replace accelerator pedal assembly.
  2. Perform "Accelerator Pedal Released Position Learning" in [PROCEDURE AFTER REPLACING ECM ].
  3. Perform "Throttle Valve Closed Position Learning" in [PROCEDURE AFTER REPLACING ECM ].
  4. Perform "Idle Air Volume Learning" in [PROCEDURE AFTER REPLACING ECM ].
INSPECTION END   
CHECK INTERMITTENT INCIDENT 
Refer to [SERVICE INFORMATION FOR ELECTRICAL INCIDENT: INTERMITTENT INCIDENT ]
INSPECTION END