With GST
WARNING: This page is about a different variant/trim than selected.
- Start engine and warm it up to normal operating temperature.
- Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
- Set D position with "OD" OFF (A/T) or 5th position (M/T), then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).NOTE: Never apply brake during releasing the accelerator pedal.
- Repeat steps 2 and 3 for five times.
- Stop the vehicle and turn ignition switch OFF.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Restart engine.
- Repeat steps 2 and 3 for five times.
- Stop the vehicle and connect GST to the vehicle.
- Check that no 1st trip DTC is displayed.
If the 1st trip DTC is displayed, go to [P0130, P0150 A/F SENSOR 1 ].