DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
Start engine and wait at least 40 seconds.
NOTE: Do not depress accelerator pedal even slightly.
Check 1st trip DTC.
If 1st trip DTC is detected, go to [P0451 EVAP CONTROL SYSTEM PRESSURE SENSOR ].