LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> Equator Premium >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Data Communication System >> Diagnostic Information and Procedure >> CAN Communication Circuit Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

CAN Communication Circuit Check

DIAGNOSIS PROCEDURE

Step Action YES NO
1  CONNECTOR INSPECTION 
  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Disconnect all the unit connectors on CAN communication system.
  4. Check terminals and connectors for damage, bend and loose connection.

Is the inspection result normal? 		 GO TO 2. Repair the terminal and connector.
2  CHECK HARNESS CONTINUITY (SHORT CIRCUIT) 
Check the continuity between the data link connector terminals.
Is the inspection result normal? 		 GO TO 3. Check the harness and repair the root cause.
3  CHECK HARNESS CONTINUITY (SHORT CIRCUIT) 
Check the continuity between the data link connector and the ground.
Is the inspection result normal? 		 GO TO 4. Check the harness and repair the root cause.
4  CHECK ECM AND IPDM E/R TERMINATION CIRCUIT 
  1. Remove the ECM and the IPDM E/R.
  2. Check the resistance between the ECM terminals.
G06446850G06446851G06446852Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
G06446850G06446851G06446852Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.

  1. 3. Check the resistance between the IPDM E/R terminals.
G06446850G06446851G06446852Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.

Is the measurement value within the specification? 		 GO TO 5. Replace the ECM and/or the IPDM E/R.
5  CHECK SYMPTOM 
Connect all the connectors. Check if the symptoms described in the "Symptom (Results from interview with customer)" are reproduced.
Inspection result 		 GO TO 6. Start the diagnosis again. Follow the trouble diagnosis procedure when past error is detected.
6  CHECK UNIT REPRODUCTION 
Perform the reproduction test as per the following procedure for each unit.
  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Disconnect one of the unit connectors of CAN communication system.
    NOTE: ECM and IPDM E/R have a termination circuit. Check other units first.
  4. Connect the battery cable to the negative terminal. Check if the symptoms described in the "Symptom (Results from interview with customer)" are reproduced.
    NOTE: Although unit-related error symptoms occur, do not confuse them with other symptoms.

Inspection result 		 Connect the connector. Check other units as per the above procedure. Replace the unit whose connector was disconnected.
scientia non olet · About LEMON Manuals