Diagnosis Procedure

DIAGNOSIS PROCEDURE

Step	Action	YES	NO
1	CHECK OIL PRESSURE WARNING LAMP Start engine. Check oil pressure warning lamp and confirm it is not illuminated. Courtesy of SUZUKI OF AMERICA CORP. OK or NG	GO TO 2.	Go to [CHANGING ENGINE OIL ]
2	CHECK INTAKE VALVE TIMING CONTROL SOLENOID VALVE Refer to [P0011, P0021 IVT CONTROL ]. OK or NG	GO TO 3.	Replace malfunctioning intake valve timing control solenoid valve.
3	CHECK CRANKSHAFT POSITION SENSOR (POS) Refer to [P0335 CKP SENSOR (POS) ]. OK or NG	GO TO 4.	Replace crankshaft position sensor (POS).
4	CHECK CAMSHAFT POSITION SENSOR (PHASE) Refer to [P0340, P0345 CMP SENSOR (PHASE) ]. OK or NG	GO TO 5.	Replace malfunctioning camshaft position sensor (PHASE).
5	CHECK CAMSHAFT (INTAKE) Check the following. Accumulation of debris on the signal plate of camshaft rear end Courtesy of SUZUKI OF AMERICA CORP. Chipping signal plate of camshaft rear end OK or NG	GO TO 6.	Remove debris and clean the signal plate of camshaft rear end or replace camshaft.
6	CHECK TIMING CHAIN INSTALLATION Check service records for any recent repairs that may cause timing chain misalignment. Are there any service records that may cause timing chain misalignment? Yes or No	Check timing chain installation. Refer to [TIMING CHAIN: REMOVAL AND INSTALLATION ]	GO TO 7.
7	CHECK LUBRICATION CIRCUIT Refer to [CAMSHAFT: REMOVAL AND INSTALLATION ] OK or NG	GO TO 8.	Clean lubrication line.
8	CHECK INTERMITTENT INCIDENT Refer to [SERVICE INFORMATION FOR ELECTRICAL INCIDENT: INTERMITTENT INCIDENT ]	INSPECTION END