| 1 |
CHECK DOOR SWITCHES INPUT SIGNAL
With SDT
Check door switches ("DOOR SW-DR", "DOOR SW-AS") in Data list mode with SDT. Refer to
[SDT FUNCTION (BCM - DOOR LOCK)
]
- When any doors are open:
DOOR SW-DR: ON
DOOR SW-AS: ON
- When any doors are closed:
DOOR SW-DR: OFF
DOOR SW-AS: OFF
Without SDT
Check voltage between BCM connector M18 or M19 terminals 12, 47 and ground.
Is the inspection result normal? |
Door switch circuit is OK. |
GO TO 2 |
| 2 |
CHECK BCM OUTPUT VOLTAGE
- Turn ignition switch OFF.
 Courtesy of SUZUKI OF AMERICA CORP.
- 2. Disconnect door switches.
- 3. Check voltage between BCM connector M18, M19 terminals 12, 47 and ground.
12 - Ground: Battery voltage
47 - Ground: Battery voltage
Is the inspection result normal? |
GO TO 3 |
Replace BCM. Refer to
[BCM (BODY CONTROL MODULE): REMOVAL AND INSTALLATION
] |
| 3 |
CHECK DOOR SWITCH CIRCUIT
- Disconnect door switch and BCM.
 Courtesy of SUZUKI OF AMERICA CORP.
- 2. Check continuity between door switch connector B8 (Front LH), B108 (Front RH) terminal 2 and BCM connector M18, M19 terminals 12, and 47.
2 - 47: Continuity should exist.
2 - 12: Continuity should exist.
- 3. Check continuity between door switch connector B8 (Front LH), B108 (Front RH) terminal 2 and ground.
2 - Ground: Continuity should not exist.
Is the inspection result normal? |
GO TO 4 |
Repair or replace harness. |
| 4 |
CHECK DOOR SWITCHES
- Disconnect door switch.
  Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
- 2. Check continuity between door switch terminals.
Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
Is the inspection result normal? |
Check switch case ground condition. |
Replace door switch. |