Diagnosis Procedure

DIAGNOSIS PROCEDURE

Step	Action	YES	NO
1	CHECK FRONT WIPER MOTOR FUSE Turn the ignition switch OFF. Check that the following fuse is not blown. Is the fuse blown?	GO TO 2	GO TO 3
2	CHECK FRONT WIPER MOTOR (LO) SHORT CIRCUIT Disconnect IPDM E/R and front wiper motor. Courtesy of SUZUKI OF AMERICA CORP. 2. Check continuity between IPDM E/R harness connector and ground. Does continuity exist?	Repair or replace harness.	Replace the fuse. (Replace IPDM E/R if the fuse is blown again.)
3	CHECK FRONT WIPER MOTOR (LO) OUTPUT VOLTAGE SDT ACTIVE TEST Turn the ignition switch ON. Courtesy of SUZUKI OF AMERICA CORP. 2. Select "FRONT WIPER" of IPDM E/R active test item. 3. While operating the test item, check voltage between IPDM E/R harness connector and ground. Is the measurement value normal?	GO TO 4	Replace IPDM E/R. Refer to [IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM): REMOVAL AND INSTALLATION ]
4	CHECK FRONT WIPER MOTOR (LO) OPEN CIRCUIT Turn the ignition switch OFF. Courtesy of SUZUKI OF AMERICA CORP. 2. Disconnect IPDM E/R and front wiper motor. 3. Check continuity between IPDM E/R harness connector and front wiper motor harness connector. Does continuity exist?	Replace front wiper motor. Refer to [WIPER MOTOR AND LINKAGE: ON-VEHICLE REPAIR ].	Repair or replace harness.