LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> Equator Base, 4D Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Data Communication System >> Diagnostic Information and Procedure >> STRG Branch Line Circuit Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

STRG Branch Line Circuit Check

DIAGNOSIS PROCEDURE

Step Action YES NO
1  CHECK CONNECTOR 
  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? 		 GO TO 2. Repair the terminal and connector.
2  CHECK HARNESS FOR OPEN CIRCUIT 
  1. Disconnect the connector of steering angle sensor.
  2. Check the resistance between the steering angle sensor harness connector terminals.
G06446846Courtesy of SUZUKI OF AMERICA CORP.

Is the measurement value within the specification? 		 GO TO 3. Repair the steering angle sensor branch line.
3  CHECK POWER SUPPLY AND GROUND CIRCUIT 
Check the power supply and the ground circuit of the steering angle sensor. Refer to [ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT): WIRING DIAGRAM [VDC] ]
Is the inspection result normal? 		 Replace the steering angle sensor. Refer to [STEERING ANGLE SENSOR: REMOVAL AND INSTALLATION ] Error was detected in the steering angle sensor branch line.
scientia non olet · About LEMON Manuals