Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF.
Connect GST to data link connector, which is located under LH dash panel near the hood opener handle.

Fig 1: Connecting GST To Data Link Connector
Courtesy of SUZUKI OF AMERICA CORP.
Turn ignition switch ON.

Fig 2: Screen Display - Program Card
Courtesy of SUZUKI OF AMERICA CORP.
Enter the program according to instruction on the screen or in the operation manual.
(*: Regarding GST screens in this section, sample screens are shown.)
Perform each diagnostic mode according to each service procedure.

Fig 3: Screen Display - Readiness Tests
Courtesy of SUZUKI OF AMERICA CORP.

For further information, see the GST Operation Manual of the tool maker.