Removal Procedure

Disconnect the rack and pinion outer tie rods from the steering knuckles. Refer to RACK AND PINION OUTER TIE ROD END REPLACEMENT .
Remove the intermediate steering shaft lower bolt. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT .
Place drain pans under the vehicle as needed.

Fig 1: Identifying Transaxle Mount Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Remove the transaxle mount bolt (1).

Fig 2: Identifying Transaxle Mount & Transaxle Mount Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Remove the transaxle mount bolts (1) and position the transaxle mount aside.

Fig 3: Identifying Power Steering Gear Inlet Hose & Power Steering Cooler Hose
Courtesy of SUZUKI OF AMERICA CORP.

NOTE:
Do not reuse the old O-Ring seals.
Disconnect the power steering gear inlet hose (2) and the power steering cooler hose (1) from the power steering gear.

Fig 4: Identifying Power Steering Gear Hoses Bracket Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Remove the power steering gear hoses bracket bolt (1).

Fig 5: Identifying Power Steering Gear Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Remove the power steering gear bolts (1).
Remove the power steering gear through the left wheel house area.
Transfer any parts as needed.