Removal Procedure

NOTE:

Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
Always route the replacement cable the same way as the original cable.

Fig 1: Identifying Underhood Bussed Electrical Center Cover
Courtesy of SUZUKI OF AMERICA CORP.

Remove the battery. Refer to BATTERY REPLACEMENT .
Remove the underhood bussed electrical center (UBEC) cover.

Fig 2: Identifying Positive Battery Cable Terminal Nut
Courtesy of SUZUKI OF AMERICA CORP.
Remove the positive battery cable terminal nut (1) from the UBEC stud.
Remove the positive battery cable terminal (2) from the UBEC stud.

Fig 3: Identifying Positive And Negative Battery Cable Clip
Courtesy of SUZUKI OF AMERICA CORP.
Remove the battery box. Refer to BATTERY BOX REPLACEMENT .
Disconnect the positive and negative battery cable clip (3) from the battery tray support bracket.
Disconnect the positive and negative battery cable clip on the side of the battery tray support bracket.
Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .

Fig 4: Identifying Positive Battery Cable Terminal Nut, Engine Wiring Harness Clip And Positive Battery Cable
Courtesy of SUZUKI OF AMERICA CORP.
Remove the positive battery cable terminal to starter solenoid nut (6).
Remove the positive battery cable from the engine wiring harness clip (3).
Remove the positive battery cable (4) lead from the starter solenoid.
Cut the tape and remove the positive battery cable from the wire loom.