Removal Procedure

Fig 1: Identifying Side View Of Connector

Courtesy of SUZUKI OF AMERICA CORP.

Side view of connector.

Fig 2: Identifying Top View Of Connector

Courtesy of SUZUKI OF AMERICA CORP.

View of top of connector.

1. Locate the assist lever and lock on the top of the connector.
   Fig 3: Depressing Lock

   Courtesy of SUZUKI OF AMERICA CORP.
2. While depressing the lock, pull the lever over and past the lock.
   Fig 4: Identifying Connector From Component

   Courtesy of SUZUKI OF AMERICA CORP.
3. Disconnect the connector from the component.
   Fig 5: Identifying Dress Cover Locking Tabs

   Courtesy of SUZUKI OF AMERICA CORP.
4. Locate the dress cover locking tabs at the rear of the connector. Use a small flat-blade tool to release the locking tabs. Repeat this procedure for the other locking tab.
   Fig 6: Identifying Inner Connector Of Rear Of Connector Housing

   Courtesy of SUZUKI OF AMERICA CORP.
5. Once the locking tabs are unlocked, slide the inner connector out of the rear of the connector housing.
   Fig 7: Releasing Terminals By Pressing On Tang

   Courtesy of SUZUKI OF AMERICA CORP.
6. Use the J 38125-12A (GM P/N 12094429) tool to release the terminals by pressing on the tang. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.