Removal Procedure

While depressing the lock, remove the connector from the component.

Fig 1: Depressing Lock
Courtesy of SUZUKI OF AMERICA CORP.
Locate the two indents of the terminal position assurance (TPA) located on the bottom of the connector body.

Fig 2: Locating Indents Of Terminal Position Assurance
Courtesy of SUZUKI OF AMERICA CORP.
Use a small flat-blade tool to very carefully raise the TPA on both sides of the connector.

Fig 3: Identifying TPA
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: The TPA cannot be removed from the connector while there are terminals present in the connector body.

Fig 4: View Of TPA
Courtesy of SUZUKI OF AMERICA CORP.

View of the TPA when removed from the connector body.
Use the J 38125-12A tool to release the terminals by inserting the tool into the left side of the terminal release cavity as shown in the graphic. Use the tool to move the terminal release to the right with a gentle prying motion. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.

Fig 5: Inserting Tool Into Left Side Of Terminal Release Cavity
Courtesy of SUZUKI OF AMERICA CORP.
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.