Component Testing

Ignition Switch 

1. Ignition OFF, disconnect the harness connector at the ignition switch.
2. Using the Resistance Test table below, check the resistance between the terminals of the ignition switch listed in each switch position.

   Resistance Test 

   RESISTANCE TEST CHART
   
   

   Ignition Switch Position	Terminals 3 and 1	Terminals 3 and 2	Terminals 3 and 5	Terminals 3 and 4	Terminals 5 and 4
   Off Key Out	Infinite	Infinite	Infinite	Infinite	Infinite
   Off Key IN	Infinite	Infinite	< 5.0 Ohms	Infinite	Infinite
   Accessory	Infinite	< 5.0 Ohms	Infinite	Infinite	Infinite
   Run	< 5.0 Ohms	< 5.0 Ohms	Infinite	Infinite	< 5.0 Ohms
   Start	< 5.0 Ohms	Infinite	Infinite	Infinite	1275-1325 Ohms

   • If any reading is not as specified, replace the ignition switch.