LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Diagnostic Information and Procedures >> Power Seat Inoperative >> Circuit/System Testing >> Seat Vertical Motor Circuit Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Seat Vertical Motor Circuit Test

  1. Ignition OFF, disconnect the harness connector at the appropriate seat vertical motor.
  2. Test for less than 5 ohms between the control circuit terminal A and ground.
    • If greater than the specified range, test the control circuit for an open/high resistance. If the circuit tests normal, test or replace the seat adjuster switch.
  3. Test for less than 5 ohms between the control circuit terminal B and ground.
    • If greater than the specified range, test the control circuit for an open/high resistance. If the circuit tests normal, test or replace the seat adjuster switch.
  4. Connect a test lamp between control circuit terminal A and control circuit terminal B.
  5. Ignition ON, command the appropriate seat motor in the UP and DOWN directions using the seat adjuster switch. The test lamp should turn ON when commanding the UP and DOWN states.
    • If the test lamp remains OFF for either of the commands, test the control circuits for a short to ground. If the circuits test normal, test or replace the seat adjuster switch.
  6. If all circuits tests normal, test or replace the appropriate seat motor.
scientia non olet · About LEMON Manuals