LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting Systems >> Diagnostic Information and Procedures >> Headlamps Malfunction >> Circuit/System Testing >> Turn Signal/Multifunction Switch Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Turn Signal/Multifunction Switch Test

  1. Ignition OFF, disconnect the X2 harness connector at the turn signal/multifunction switch.
  2. Ignition OFF, verify that a test lamp illuminates between the ground circuit terminal B and B+.
    • If the test lamp does not illuminate, test the ground circuit for an open/high resistance.
  3. Ignition OFF, verify that a test lamp illuminates between the ground circuit terminal F and B+.
    • If the test lamp does not illuminate, test the ground circuit for an open/high resistance.
  4. Ignition ON, verify the scan tool Flash to Pass Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the BCM.
  5. Verify the scan tool High Beam Select Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal D for a short to ground. If the circuit tests normal, replace the BCM.
  6. Install a 3A fused jumper wire between the signal circuit terminal C and ground. Verify the scan tool Flash to Pass Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the BCM.
  7. Install a 3A fused jumper wire between the signal circuit terminal D and ground. Verify the scan tool High Beam Select Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the BCM.
  8. If all circuits test normal, test or replace the turn signal/multifunction switch.