LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Assisted Steering System >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Remove the front tire/wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  2. Place drain pans under the vehicle as needed.
  3. Remove as much fluid from the remote power steering fluid reservoir as possible.
    Fig 1: Identifying Power Steering Gear Inlet Hose From Power Steering Pump
    G04844022Courtesy of SUZUKI OF AMERICA CORP.
  4. Disconnect the power steering gear inlet hose fitting (1) from the power steering pump.
    Fig 2: Identifying Power Steering Gear Inlet Hose
    G04844023Courtesy of SUZUKI OF AMERICA CORP.
  5. Disconnect the power steering gear inlet hose fitting (1) from the steering gear.
  6. Remove the power steering gear inlet hose from the vehicle.
scientia non olet · About LEMON Manuals