LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Diagnostic Information and Procedure >> DTC B0090 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
  • The vehicle rollover sensor
  • The SDM module
  • The vehicle rollover sensor harness connector
  • The SDM wiring harness connector
  1. Verify DTC B0090 39 is not set.
    • If DTC is set, replace the rollover sensor.
  2. Ignition OFF, disconnect the harness connector at the rollover sensor and the SDM.
  3. Test for less then 5 ohms between the rollover sensor ground circuit terminal 6 and ground.
    • If greater then the specified range, test the circuit for an open/high resistance.
  4. Test for less then 5 ohms between the serial data circuit terminal 5 and the SDM occupant sensor serial data circuit terminal 58.
    • If greater then the specified range, test the circuit for a short to ground or an open/high resistance.
  5. Ignition ON, test for less than 1 volt between the serial data circuit terminal 5 and ground.
    • If greater then the specified range, test the circuit for a short to voltage.
  6. Verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
    • If the test lamp does not illuminate, test the circuit for an open/high resistance. If the circuit fuse is open, test the circuit for a short to ground, if the circuit tests normal, replace the rollover sensor.
  7. With a scan tool, clear DTCs. Verify DTC B0090 is not set.
    • If DTC is set, replace the SDM.
scientia non olet · About LEMON Manuals