LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation And A/C >> Repair Instructions >> Sealing Washer Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

NOTE: Flat washer type seals do not require lubrication.
  1. Inspect the new seal washer for any signs of cracks, cuts, or damage.

    Do not use a damaged seal washer.

  2. Remove the cap or tape from the A/C refrigerant components.
    Fig 1: Precaution For Seal Washer
    G05470445Courtesy of SUZUKI OF AMERICA CORP.
  3. Using a lint-free clean, dry cloth, clean the sealing surfaces of the A/C refrigerant components.
  4. Carefully install the new seal washer onto the A/C refrigerant component.

    The washer must completely bottom against the surface of the fitting.

    NOTE: After tightening the A/C components, there should be a slight sealing washer gap of approximately 1.2 mm (3/64 in) between the A/C line and the A/C component.
  5. Assemble the remaining A/C refrigerant components. Refer to the appropriate repair procedure.
scientia non olet · About LEMON Manuals