LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P2122, P2123, P2127, P2128, or P2138 >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

  1. Install a 3A fused jumper wire between the 5-volt reference terminal of the applicable APP sensor and 5 volts. Install a jumper wire between the applicable low reference terminal and a ground.
  2. Sweep the sensor through the entire range while monitoring the voltage between the appropriate signal circuit terminal and the low reference terminal with a DMM. The voltage for APP 1 should vary between 0.90-4.35 volts without any spikes or dropouts. The voltage for APP 2 should vary between 0.40-2.20 volts without any spikes or dropouts.
    • If the voltage is not within the specified range or is erratic on either APP sensor, replace the accelerator pedal assembly.
scientia non olet · About LEMON Manuals