Conditions for Running the DTC

DTC P0121, P0122, P0123, P0221, P0222, P0223, P0335, P0336, or P0338 is not set.
The engine speed is between 420-7,000 RPM and steady.
The engine run time is greater than 45 seconds.
The evaporative emissions (EVAP) leak detection is not active.
The delivered torque signal is greater than 10 percent at idle.
The delivered torque signal is between 10-30 percent with the transmission in drive.
The intake air temperature (IAT) is greater than -30 °C (-22 °F).
The A/C compressor clutch is not changing states.
The torque management is not active.
The antilock brake system/traction control system (ABS/TCS) is not active.
The ECM is not receiving a rough road signal.
The fuel level is greater than 12 percent.
The ECM is not in fuel cut-off or decel fuel cut-off mode.
The throttle angle is steady.
DTCs P0300 through P0306 run continuously when the above conditions exist for at least 1000 engine revolutions.