Conditions for Running the DTC

Condition 1 

• Before the ECM can report DTC P0116 failed, DTC P0101 must run and pass.
• DTC P0112, P0113, P0117, P0118, P0119, or P2610 is not set.
• The engine run time of the previous ignition cycle was greater than 10 minutes.
• The calculated engine cool down of the previous test was greater than 50 °C (120 °F).
• The ignition was OFF for greater than 330 minutes after the previous engine shut down.
• The accumulated air mass of the previous ignition cycle was greater than 6,000 grams.
• DTC P0116 runs once an ignition cycle when the above conditions are met.

Condition 2 

• Before the ECM can report DTC P0116 failed, DTC P0101 must run and pass.
• DTC P0112, P0113, P0117, P0118, or P0119 is not set.
• The ECT at the previous engine shut down is greater than 82 °C (180 °F).
• The block heater is not detected.
• DTC P0116 runs once an ignition cycle when the above conditions are met.