LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0016, P0017, P0018, or P0019 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition ON, observe the DTC information with a scan tool. Verify that none of the following DTCs are set. DTC P0010, P0013, P0020, P0023, P0335, P0336, P0338, P0341, P0342, P0343, P0346, P0347, P0348, P0366, P0367, P0368, P0391, P0392, P0393, P2088, P2089, P2090, P2091, P2092, P2093, P2094, or P2095.
  2. Idle the engine at normal operating temperature for 10 minutes. DTC P0016, P0017, P0018, or P0019 should not set.
    • If a DTC sets, inspect for the following:
      • The correct installation of the camshaft sensors
      • The correct installation of the crankshaft sensor
      • A timing chain tensioner condition
      • An incorrectly installed timing chain
      • Excessive play in the timing chain
      • A timing chain that jumped teeth
      • A crankshaft reluctor wheel that has moved in relationship to top dead center (TDC) on the crankshaft
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals