Component Testing
- Ignition OFF, disconnect the harness connector at the primary and secondary fuel level sensors.
- While sweeping the primary fuel level sensor through its full range of motion, test for a minimum value less than 41 ohms and a maximum value greater than 119 ohms between signal terminal A and the low reference terminal B.
- If not within the specified range, replace the primary fuel level sensor.
- While sweeping the secondary fuel level sensor through its full range of motion, test for a minimum value less than 41 ohms and a maximum value greater than 119 ohms between signal terminal E and the low reference terminal B.
- If not within the specified range, replace the secondary fuel level sensor.