Component Testing
- Ignition OFF, disconnect the harness connector at the appropriate door latch assembly.
- With the switch in the open position, test for infinite resistance between the signal terminal and the ground terminal listed below:
- Front passenger door latch assembly signal terminal 1 and ground terminal 3
- Left and right rear door latch assembly signal terminal 4 and ground terminal 6
- If not the specified value, replace the door latch assembly.
- With the switch in the closed position, test for less than 1.0 ohm between the signal terminal and the ground terminal listed below:
- Front passenger door latch assembly signal terminal 1 and ground terminal 3
- Left and right rear door latch assembly signal terminal 4 and ground terminal 6
- If not the specified value, replace the door latch assembly.