LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Diagnostic Information and Procedures >> DTC B1424 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the TDM.
  2. Probe the ground circuit terminal 3 with a test lamp that is connected to B+. The test lamp should illuminate.
    • If the test lamp does not illuminate, then test the ground circuit for an open/high resistance.
  3. Ignition ON. measure the voltage between the B+ circuit terminal 1 and the ground circuit terminal 3. Verify that the difference between the voltage at the TDM connector and the voltage at the battery terminals is less than 1 volt.
    • If greater than the specified value, test the B+ circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, replace the TDM.
scientia non olet · About LEMON Manuals