LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Diagnostic Information and Procedures >> DTC C0394 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector X2 at the rear differential clutch control module.
  2. Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal 2 and ground.
    • If the test lamp illuminates, test the signal circuit for a short to voltage.
  3. Ignition OFF, test for infinite resistance between the signal circuit terminal 2 and ground.
    • If less than the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the rear wheel drive module clutch housing.
  4. Test for 310-113K ohms of resistance between the signal circuit terminal 2 and the low reference circuit terminal 4.
    • If less than the specified range, test both circuits for a short together. If the circuits test normal, replace the rear wheel drive module clutch housing.
    • If greater than the specified range, test both circuits for an open/high resistance. If the circuits test normal, replace the rear wheel drive module clutch housing.
  5. If all circuits test normal, replace the CCM.
scientia non olet · About LEMON Manuals