LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Tire Pressure Monitoring System >> Diagnostic Information and Procedures >> Low Tire Pressure Indicator Always On >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

NOTE: When a TPM DTC is set, the tire pressure monitor indicator icon will flash for 1 minute after the IPC bulb check is completed and then remains illuminated. If equipped with a DIC, a service tire monitor type message will also be displayed.
Low tire pressure in one or more tires is indicated by a continuously illuminated tire pressure monitor indicator icon after the IPC bulb check is completed. If equipped with a DIC, a check tire pressure type message will also be displayed.
  1. Inflate all tires to the proper pressure and drive the vehicle over 40 km/h (25 mph) for greater than 2 minutes. Refer to VEHICLE CERTIFICATION, TIRE PLACARD, ANTI-THEFT AND SERVICE PARTS ID LABEL .
  2. Using the J-46079, activate each tire pressure sensor and record each sensors tire pressure reading. Check the tire pressures with a known accurate hand held tire pressure gauge. Verify that the pressure readings from the special tool do not differ more than 27.6 kPa (4 psi) from the actual tire pressure readings.
    • If not within the specified range, replace the suspect tire pressure sensor.
  3. Using a scan tool, enable the TPM learn mode. Use the J-46079 in simulate mode to learn 4 simulated sensor transmissions into the RCDLR. Observe tire pressures in the scan tool data display. Verify the simulated tire pressures do not differ more than +/- 27.6 kPa (4 psi) of the scan tool reading.
    • If not within the specified range, replace the RCDLR.
  4. Using a scan tool, select instrument panel special functions Lamp Test. Command the instrument panel warning lamps OFF. Verify the tire pressure monitor indicator icon turns OFF.
    • If the tire pressure monitor icon does not turn OFF, replace the IPC.
  5. Ignition ON, use the scan tool to setup the Tire Type/Pressure Selection in the RCDLR Module Setup menu. Refer to the VEHICLE CERTIFICATION, TIRE PLACARD, ANTI-THEFT AND SERVICE PARTS ID LABEL . Verify the tire pressure monitor indicator icon turns OFF.
    • If the tire pressure monitor icon does not turn OFF, replace the RCDLR.
scientia non olet · About LEMON Manuals