LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting Systems >> Diagnostic Information and Procedures >> Interior Backlighting Malfunction >> Circuit/System Testing >> Dimmer Switch Circuit Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Dimmer Switch Circuit Test

  1. Ignition OFF, disconnect the harness connector at the dimmer switch.
  2. Ignition OFF, verify that a test lamp illuminates between the ground circuit terminal C and B+.
    • If the test lamp does not illuminate, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool BCM Dimming Control Signal parameter is less than 0.1 volts.
    • If greater than the specified range, test the signal circuit terminal B for a short to voltage. If the circuit tests normal, replace the BCM.
  4. Ignition ON, test for B+ between the I/P dimming voltage reference circuit terminal D and ground.
    • If less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. Install a 3A fused jumper wire between the signal circuit terminal B and the voltage reference circuit terminal D. Verify the scan tool BCM Dimming Control Signal parameter is greater than 2.6 volts.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  6. If all circuits test normal, test or replace the dimmer switch.
scientia non olet · About LEMON Manuals