LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> XL7 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Data Communication System >> Diagnostic Informations and Procedures >> Power Mode Mismatch >> Component Testing >> Ignition Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition Switch

  1. Ignition OFF, disconnect the harness connector at the ignition switch.
  2. Using the Resistance Test table below, check the resistance between the terminals of the ignition switch listed in each switch position.

    Resistance Test 

    IGNITION SWITCH POSITION AND RESISTANCE SPECIFICATION

    Ignition Switch Position Terminals 3 and 1 Terminals 3 and 2 Terminals 3 and 5 Terminals 3 and 4 Terminals 5 and 4
    Off Key Out Infinite Infinite Infinite Infinite Infinite
    Off Key IN Infinite Infinite < 5.0 Ohms Infinite Infinite
    Accessory Infinite < 5.0 Ohms Infinite Infinite Infinite
    Run < 5.0 Ohms < 5.0 Ohms Infinite Infinite < 5.0 Ohms
    Start < 5.0 Ohms Infinite Infinite Infinite 1275-1325 Ohms
    • If any reading is not as specified, replace the ignition switch.
scientia non olet · About LEMON Manuals