| Inspect for an oil-soaked clutch disc. |
Correct the leak at its source and install a new clutch disc. |
| Inspect for a worn facing or facing torn from the disc. |
Replace the worn disc with a new disc. |
| Inspect for a warped pressure plate or a warped flywheel. |
Replace the warped pressure plate or the warped flywheel. |
| Inspect for a weak diaphragm spring. |
Replace the pressure plate. |
| Inspect for a driven plate that is not seated. |
Start the engine 30-40 times. Do not overheat the engine. |
| Inspect for a driven plate that is overheated. |
Allow the driven plate to cool. |
| Incorrect hydraulic clutch pedal height, not allowing the clutch master cylinder to return |
Measure the hydraulic clutch release point. Refer to Clutch Pedal Free Travel Adjustment (Cable) or Clutch Pedal Free Travel Adjustment (Hydraulic) . |
| Hydraulic clutch master cylinder binding or seized |
Replace the clutch master cylinder. Refer to Clutch Master Cylinder Replacement . |
| Hydraulic clutch actuator cylinder binding or seized |
Replace the clutch actuator cylinder. |
| Kinked or damaged hydraulic clutch hydraulic hose |
- Inspect for the correct routing of the clutch hydraulic hose.
- Route the hose properly.
- Inspect for loose or faulty engine mounts that may allow the hydraulic hose to be kinked.
- Repair or replace the clutch hydraulic hose if it is damaged.
|
| Improper clutch cable adjustment |
Adjust clutch cable. Refer to Clutch Assembly Adjustment . |
| Rusted clutch cable |
Replace the clutch cable. Refer to Clutch Cable Replacement . |