LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> Swift + >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation, And Air Conditioning >> Repair Instructions >> Compressor Clutch Plate/Hub Assembly Install (SP10 Compressor)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Compressor Clutch Plate/Hub Assembly Install (SP10 Compressor)

    Fig 1: Clutch Drive Assembly
    GM1886998Courtesy of GENERAL MOTORS CORP.
  1. Place the clutch drive assembly to match the shaft serration with the drive hub serration.
  2. Gently insert the clutch drive assembly.
  3. Check the air gap with the feeler gage roughly by pressing the clutch drive assembly before fastening the shaft bolt.

    Specification:  0.3-0.7 mm (0.012-0.028 in)

    IMPORTANT: If the air gap is correct, proceed to the next step. If not, change the shim to meet the specified air gap.
    4. Fig 2: Clutch Hub Holding Tool
    GM1886996Courtesy of GENERAL MOTORS CORP.
  4. Use the DW-610-010  clutch hub holding tool (1) to keep the clutch drive assembly from turning. See Special Tools .
  5. Place the washer before fastening the shaft bolt.

    Tighten:  Tighten the shaft bolt to 12-15 N.m (106-133 lb in).

  6. Recheck the air gap with the feeler gage.
scientia non olet · About LEMON Manuals