LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> Swift + >> Repair and Diagnosis >> General Information >> Reset Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 22
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TPMS Reminder Reset - Procedure 22

NOTE: When a spare tire is mounted, a wheel is replaced or rotated, or tire pressure has been adjusted, TPM system will need to be recalibrated.
CAUTION: DO NOT recalibrate TPM system until all problems are fixed and tire pressure in all 4 tires has been adjusted. If recalibration is done when tire pressures are incorrect, TPM system will not work properly and may not set an alert when a tire pressure is low or high.
  1. Turn ignition switch to OFF position.
  2. Ensure all tire pressures are adjusted to the pressure recommended on tire pressure label.
  3. Turn ignition ON with engine OFF.
  4. Press and hold the MODE button until DIC display reads "LOW TIRE PRESSURE HOLD SET TO RESET".
  5. Press and hold SET button chime sounds and "TIRE PRESSURE RESET" is displayed and a chime sounds 3 times.
  6. Release SET button and DIC will display "TIRE PRESSURE NORMAL".
    NOTE: If low tire pressure warning message is still set, TPM system has not reset. Repeat procedure. If it does not work after two tries, refer to appropriate service information.
  7. After resetting, the TPM system requires up to 5 miles of driving in each of the following speed ranges to complete the calibration process:
    • 25-40 mph (40-64 km/h).
    • 40-60 mph (65-96 km/h).
    • 60-85 mph (96-136 km/h).
      NOTE: Learning process does not need to be completed during a single trip.
scientia non olet · About LEMON Manuals