Circuit/System Verification (w/TAC)
- Ignition ON, observe the DTC information with a scan tool. Verify DTC P0641 is not set.
- Ignition ON, observe the TP Sensor percentage parameters with a scan tool. Verify the scan tool TP sensors parameters are between 7-21 percent.
- Observe both TP Sensor percentage parameters while pressing the accelerator pedal from a closed throttle to WOT. Both TP Sensor percentage parameters should change.
- Rapidly depress the accelerator pedal from the rest position to the WOT position and release pedal. Repeat the procedure several times. DTCs P0122, P0123, P0222, P0223, or P2135 should not set.
- Slowly depress the accelerator pedal to WOT and then slowly return the pedal to closed throttle. Repeat the procedure several times. DTCs P0122, P0123, P0222, P0223, or P2135 should not set.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.