Installation Procedure

Fig 1: View Of Seal And Joint Assembly

Courtesy of GENERAL MOTORS CORP.

Install the seal onto the axle shaft.
Fill the joint seal with 110-130 grams (3.9-4.6 ounces) of the recommended grease. Repack the joint with 110-130 grams (3.9-4.6 ounces) of the recommended grease.

Fig 2: View Of Large Seal Retaining Clip And Small Seal Retaining Clamp

Courtesy of GENERAL MOTORS CORP.

Fig 3: Crimping New Small Seal Retaining Clamp And New Large Seal Retaining Clamp With J 35566

Courtesy of GENERAL MOTORS CORP.

Crimp the new small seal retaining clamp and the new large seal retaining clamp using the J 35566 (1). See Special Tools .
Install the cross groove joint seal assembly. Refer to Wheel Drive Shaft Inner Joint and Boot Replacement (Automatic) or Wheel Drive Shaft Inner Joint and Boot Replacement (Manual) .