LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> Swift + >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

  1. Disconnect the negative battery cable.
    2. Fig 1: Steering Column Panels
    GM1715979Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws (6, 7, 8) and the lower steering column cover panel (5).
    3. Fig 2: Key Reminder Switch
    GM1716043Courtesy of GENERAL MOTORS CORP.
  3. Complete the following steps in order to remove the key reminder switch (3):
    1. Remove the steering wheel. Refer to Steering Wheel Replacement (Hatchback) or Steering Wheel Replacement (Notchback) .
    2. Remove the screws (1,2).
    3. Remove the key reminder switch.
    4. Disconnect the key reminder switch connector.
    4. Fig 3: Ignition Lock Cylinder
    GM1716019Courtesy of GENERAL MOTORS CORP.
  4. Complete the following steps in order to remove the ignition lock cylinder (2):
    1. Turn the key to the ACC position.
    2. Use a 2.5 allen wrench, or equivalent, in order to press the detent spring in the ignition lock cylinder.
    3. Remove the ignition lock cylinder.
    5. Fig 4: Ignition Switch
    GM1716033Courtesy of GENERAL MOTORS CORP.
  5. Complete the following steps in order to remove the ignition switch (2):
    1. Remove the ignition switch screw (1).
    2. Remove the ignition switch.
    3. Disconnect the ignition switch connector.
    6. Fig 5: Key Hole Illumination
    GM1716070Courtesy of GENERAL MOTORS CORP.
  6. Complete the following steps in order to remove the key hole illumination (1):
    1. Remove the key hole illumination screw (2).
    2. Remove the key hole illumination.
    3. Disconnect the key hole illumination connector.
scientia non olet · About LEMON Manuals