LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2008 >> Swift + >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls And Fuel - 1.6L - Introduction (2 Of 2) >> Repair Instructions >> Heated Oxygen Sensor 2 Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: View Of Heated Oxygen Sensor And Electrical Connectors
    GM1241945Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
    2. NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice .
    NOTE: Do not solder heated oxygen sensor wires. Soldering the wires will result in the loss of the air reference to the sensor. Refer to WIRING SYSTEMS AND POWER MANAGEMENT - CONNECTOR TERMINAL REPAIRS & IGNITION SWITCH TROUBLESHOOTING for proper wire and connection repair techniques.
  2. Disconnect the electrical connector.
  3. Remove the heated oxygen sensor 2 (HO2S2).
scientia non olet · About LEMON Manuals