DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
EVAP leak check model:
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
- The following DTCs are not detected: DTCs related to MAF sensor and A/F sensor
Non-EVAP-leak-check model:
- Intake air temperature at engine start: -10 °C (14 °F) to 80 °C (176 °F)
- Intake air temperature: -10 °C (14 °F) to 70 °C (158 °F)
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
- The following DTCs are not detected: DTCs related to MAF sensor, ECT sensor, IAT sensor, barometric pressure sensor and A/F sensor
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and print Freeze Frame Data or write them down using scan tool.
- Clear DTC using scan tool.
- Start engine and warm up to normal operating temperature.
- Operate vehicle with condition as noted freeze frame data for 5 min.
- Stop vehicle and check DTC and pending DTC.